I've got an HRG rocker cover I'd like to use on my car when it is back together. It is currently un-drilled where the breather pipe normally comes out although has the cast in boss for one. Could anyone offer any advice/experience on how this was accomplished on the original rocker covers or how you have achieved it subsequently. I'm currently using a 1300GT A series but will eventually fit a proper S lump (When I can find one I can afford!)
Ta,
Paul
HRG/Alexander Rocker cover advice.
-
paul1275s
- Basic 850
- Posts: 48
- Joined: Thu Jul 07, 2011 6:09 pm
- Location: East Sussex
-
mk1
- Site Admin
- Posts: 19846
- Joined: Thu Jun 24, 2010 11:30 am
- Location: Away with the Faries
- Has thanked: 3 times
- Been thanked: 8 times
Re: HRG/Alexander Rocker cover advice.
I have drilled the corner 1/2" and bent a small pipe up in copper or mild steel, that I have glued into the breather with JB weld.