While working on mating my engine and gearbox, I failed to note the original orientation of the idler gear. The only distinguishing feature I can see is that one end of the 'axle' has a larger, chamfered hole. Otherwise, the axles are the same length, diameter, so the gear will fit either way.
There are no wear patterns that give me a clue, so I'm stuck. Does anyone know which way it goes?
Idler gear orientation - A+
-
Benny
- 850 Super
- Posts: 225
- Joined: Fri Feb 01, 2013 10:03 pm
- Location: San Diego, CA
Idler gear orientation - A+
You do not have the required permissions to view the files attached to this post.
-
Spider
- 1275 Cooper S
- Posts: 4805
- Joined: Mon May 07, 2012 6:10 am
- Location: Big Red, Australia
- Has thanked: 125 times
- Been thanked: 34 times
Re: Idler gear orientation - A+
It will go in either way. Shouldn't present any problems especially as there is no noticeable wear.
-
Benny
- 850 Super
- Posts: 225
- Joined: Fri Feb 01, 2013 10:03 pm
- Location: San Diego, CA
Re: Idler gear orientation - A+
Thanks for the reply. I was able to speak with the guy who built my gearbox this morning, and he agreed....it's not critical.