Holes on inner wing

skorstensfejeren · Post by **skorstensfejeren** » Thu Aug 16, 2012 8:05 pm

Hi guy´s...

Can anyone help with the correct measures for drilling the holes for the early blower... as they need be there if it should be correct, with or without blower...

They are marked with a blue ring here...

Thanks in advance...

Post by **Fanfaniracing** » Thu Aug 16, 2012 9:13 pm

Hi René

This is the best available pic of the inner Wing of my november 62 Austin Cooper.

I have also the black blower mounted in the inner Wing. The Car on the photo is unwelded and original.

hope it helps

regards Fabian

skorstensfejeren · Post by **skorstensfejeren** » Fri Aug 17, 2012 10:05 pm

Hi..

Thanks for the reply...I need the correct measures for drilling the holes?? anuýone help with a draw with measures??

Regards René

Post by **IAIN** » Sat Aug 18, 2012 12:34 pm

Specially for you ! The measurements are taken from a tape measure so are as close as I could get.

http://i50.tinypic.com/117bpqx.jpg

http://i47.tinypic.com/334nprl.jpg

skorstensfejeren · Post by **skorstensfejeren** » Sat Aug 18, 2012 6:05 pm

IAIN wrote:Specially for you ! The measurements are taken from a tape measure so are as close as I could get.

http://i50.tinypic.com/117bpqx.jpg

http://i47.tinypic.com/334nprl.jpg

IAIN....

You´re my man..

Thanks, a great help from you...

Best regards René

mk1-forum.net

Holes on inner wing

Holes on inner wing

Re: Holes on inner wing

Re: Holes on inner wing

Re: Holes on inner wing

Re: Holes on inner wing