Hello. Fitting a vintage very basic 70s radio which has Bluetooth
Is there any terminal in the fuse box I can get a live feed from without disturbing ignition switch. Radio doesn't need a permanent live feed
Thanks
Vintage Radio
-
- Basic 850
- Posts: 86
- Joined: Thu Aug 18, 2016 7:53 am
- Location: Farnborough
Re: Vintage Radio
Pick a green or white wire. Assuming you’re not positive earth.
1968 Cooper
1964 Pick up
1964 Pick up
-
- 1275 Cooper S
- Posts: 923
- Joined: Sun Jun 27, 2010 8:44 am
- Location: Southern Tablelands (Oz)
Re: Vintage Radio
However, if your car’s like mine (a few POs
then relying on them to have always done the right thing and used the correct wire can be dangerous...
A simple bulb tester will allow you find a live terminal (ignition switched or not as desired).
And a simple radio doesn’t consume much power so its easier to find a suitable live source under the dash than to run a new wire all the way to the fuse block. An in-line fuse is easily added if desired...
Cheers, Ian

A simple bulb tester will allow you find a live terminal (ignition switched or not as desired).
And a simple radio doesn’t consume much power so its easier to find a suitable live source under the dash than to run a new wire all the way to the fuse block. An in-line fuse is easily added if desired...
Cheers, Ian
- Robbie224
- 850 Super
- Posts: 147
- Joined: Sat Apr 30, 2022 1:23 am
- Location: Portsmouth
- Been thanked: 6 times
Re: Vintage Radio
Thanks guys appreciate the replies and advice. It's a fresh rebuild ( not done by myself ) so assuming all wiring OK. Thinking I'd wire it through a basic on/off switch as permanent live feed would keep tune dial illuminated when mini running without wish to use radio.
-
- 1275 Cooper S
- Posts: 932
- Joined: Mon May 06, 2019 12:33 pm
- Location: Worcester
- Has thanked: 10 times
- Been thanked: 5 times
Re: Vintage Radio
Modern radios usually have a permanent live feed and a trigger from the switched live. So it can both come on/off with the key and be turned on separately
Re: Vintage Radio
If you have a two fuse fuse box then connect to terminal 3 for a switched feed and place an in-line fuse between this connection and the radio. If you want a permanent feed then connect to terminal 1 with an in-line fuse.
The complete wiring diagram with legend can be found on the main site by clicking on the link below. Electrical system can be found at page 176.
https://mk1-performance-conversions.co. ... l_1968.pdf
.
The complete wiring diagram with legend can be found on the main site by clicking on the link below. Electrical system can be found at page 176.
https://mk1-performance-conversions.co. ... l_1968.pdf
.
You do not have the required permissions to view the files attached to this post.
- Robbie224
- 850 Super
- Posts: 147
- Joined: Sat Apr 30, 2022 1:23 am
- Location: Portsmouth
- Been thanked: 6 times
Re: Vintage Radio
Thanks every one. All much appreciated. It's a 71 mini GT only has one fuse box old original type with glass fuses. Found out which terminal is live feed so going to connect radio from there through a on/off switch because being radio is Bluetooth it be on constantly when ignition is on which I don't want as I won't always want radio on every journey. Switch seems best result for me.