Door drain tubes

[harrymini]

Bought 4x door drain tubes from minispares, tried a few times over the build to get them to fit but having no luck, am i doing something wrong or is there a better product out there?
My metal tubes that the drain tube goes onto on the top and slides inside on the bottom (i think it has been a while since i looked) are original.

[Polarsilver]

I had the same issue.. my solution i reduced down the circumference of the MS Drain Tubes so they located in the lower door location Tubes ..i should have complained .. but just needed to get the job sorted.

[Cammsjb]

I found a rubber tube manufacturer online who supplied me with a length of black tube with an internal diameter to fit around the top metal pipe and an outside diameter that just passed through the hole in the bottom of the door, matched the original tubes perfectly.

[Dearg1275]

I found a rubber tube manufacturer online who supplied me with a length of black tube with an internal diameter to fit around the top metal pipe and an outside diameter that just passed through the hole in the bottom of the door, matched the original tubes perfectly.

So share! Who were they?

D

[Cammsjb]

This is where I obtained the tube from:

www.hilltop-products.co.uk

[Polarsilver]

i had some new Minispares Drain Tube arrive only last week and it looks to be the correct size

[Gareth Brandt]

Think this is the tubing, have used it myself
https://www.hilltop-products.co.uk/cabl ... g-8mm.html

[Cammsjb]

The size I used was 9mm id and 12.6mm od. which is the nearest to original 3/8" id and 1/2" od.

[Gareth Brandt]

The size I used was 9mm id and 12.6mm od. which is the nearest to original 3/8" id and 1/2" od.

Yes you are right, just looked at the lable on the bag, this is what I use https://www.hilltop-products.co.uk/cabl ... g-9mm.html