Page 1 of 1
Underseal Cowboys
Posted: Sat Apr 20, 2013 1:22 pm
by SteveG
Why did / do people feel the need to spray 4mm of underseal behind dash panels, on parcel shelf, all over engine bay, boot and all over my floor, back seat and under the car (can understand the last one I guess)
grrrr
days and days of scraping and still not finished.
Re: Underseal Cowboys
Posted: Sat Apr 20, 2013 5:12 pm
by 61austinseven
Have you heated it up before scrapping.I had to do it on my own car.
It does take a bit of time but you get there.
Re: Underseal Cowboys
Posted: Sun Apr 21, 2013 12:18 pm
by SteveG
Don't worry, I tried all methods.
In the end I found heat gun and scraper to be the best. Some stuff is easy to get off but others are baked on hard.
Just venting.. I feel better now
It's all off and looking good.
Re: Underseal Cowboys
Posted: Sun Apr 21, 2013 2:14 pm
by JC T ONE
SteveG wrote:
Why did / do people feel the need to spray 4mm of underseal
all over engine bay
Welcome to the fun world of Mini restoration
My car also had this ALL over the engine bay.
It was sprayed on so thick, that it had covered both holes, and the plates with FE and body number.
Re: Underseal Cowboys
Posted: Sun Apr 21, 2013 9:48 pm
by captain
Had a very similiar experience hard work to get it all off, but well worth the effort,as you see in the before and after pictures