mk1-forum.net

Posted: **Tue Jan 22, 2013 12:09 pm**

Were there any????

Cheers. Mark

Posted: **Tue Jan 22, 2013 1:43 pm**

Head is as per a Downton head but with a larger font stamp. I am not aware of any block markings.

M

Posted: **Tue Jan 22, 2013 2:33 pm**

Cheers Mark. Now the question is what markings did Downton use? Us mere mortals think of this as stuff of urban myth....

Posted: **Tue Jan 22, 2013 2:37 pm**

Looking at cylinder head as if it's in the car.

In the top left hand corner is the amount skimmed in thou & the chamber vol in CC's

Stamped vertically at the heater tap end is the job number.

That it.

M

Posted: **Thu Jan 02, 2014 3:05 pm**

I've got a head I think is a Longman head. Is there anyone who can verify specs for these?

Posted: **Fri Jan 03, 2014 6:27 am**

Page 3 and 4 of Longmans catalog its on the main site;

http://mk1-performance-conversions.co.u ... ongman.pdf

It even has pictures of where to find them

Posted: **Fri Jan 03, 2014 7:17 am**

Well, I was more curious to find the spec on my head. If it was a MED or Swiftune head, I would know who to call. Longman, no.

On a sidenote. What was the reason for Longman not being the top Mini racing parts supplier anymore. What happened?

mk1-forum.net

Longman head and block identification marks???

Longman head and block identification marks???

Re: Longman head and block identification marks???

Re: Longman head and block identification marks???

Re: Longman head and block identification marks???

Re: Longman head and block identification marks???

Re: Longman head and block identification marks???

Re: Longman head and block identification marks???