Page 1 of 1
Holes on inner wing
Posted: Thu Aug 16, 2012 8:05 pm
by skorstensfejeren
Hi guy´s...
Can anyone help with the correct measures for drilling the holes for the early blower... as they need be there if it should be correct, with or without blower...
They are marked with a blue ring here...
Thanks in advance...
Re: Holes on inner wing
Posted: Thu Aug 16, 2012 9:13 pm
by Fanfaniracing
Hi René
This is the best available pic of the inner Wing of my november 62 Austin Cooper.
I have also the black blower mounted in the inner Wing. The Car on the photo is unwelded and original.
hope it helps
regards Fabian
Re: Holes on inner wing
Posted: Fri Aug 17, 2012 10:05 pm
by skorstensfejeren
Hi..
Thanks for the reply...I need the correct measures for drilling the holes?? anuýone help with a draw with measures??
Regards René
Re: Holes on inner wing
Posted: Sat Aug 18, 2012 12:34 pm
by IAIN
Specially for you ! The measurements are taken from a tape measure so are as close as I could get.
http://i50.tinypic.com/117bpqx.jpg
http://i47.tinypic.com/334nprl.jpg
Re: Holes on inner wing
Posted: Sat Aug 18, 2012 6:05 pm
by skorstensfejeren
IAIN....
You´re my man..
Thanks, a great help from you...
Best regards René
