Page 1 of 1
front wheel toe out settings
Posted: Fri Oct 28, 2011 10:46 am
by pad4
Hey chaps
Any one know what 1/16 toe out would be in mm and also in degrees / minutes for a 10" wheel (and whats the maths behind the conversion)
Thanks guys
Re: front wheel toe out settings
Posted: Sat Oct 29, 2011 4:41 pm
by Red1967
Straight from the Haynes Manual
Front Wheel Alignment - 0.0625 in ( 1.58mm ) Toe out, unladen
Castor Angle - 3 degrees +/- 1 degree positive, unladen
Camber Angle 2 degrees +/- 1 degree, unladen
Swivel Hub inclination - 9 degrees 30 minutes, unladen
Hope that helps
Todd
Re: front wheel toe out settings
Posted: Sun Oct 30, 2011 12:47 pm
by ivor badger
22 minutes
Re: front wheel toe out settings
Posted: Sun Oct 30, 2011 5:35 pm
by Red1967
I guess my manual has a miss print.
Re: front wheel toe out settings
Posted: Sun Oct 30, 2011 6:34 pm
by ivor badger
Red1967 wrote:I guess my manual has a miss print.
No, your manual quoted the toe out in inches/mm. 22 minutes is the 1/16" diemension coverted to angular.