hi,
I'm looking for factory drawing of a 12g940 cylinder head or any smallbore, with all dimensions.
I already have a drawing for a 12g295 available on this site, but it is difficult to read.
so if anyone has a drawing. just let me know.
Regards
Factory drawing cylindre head
-
baptiste
- Basic 850
- Posts: 68
- Joined: Wed May 27, 2015 5:32 pm
- Location: France
-
5portsrock
- 998 Cooper
- Posts: 559
- Joined: Thu Jun 24, 2010 5:21 pm
- Location: Hampshire
- Has thanked: 9 times
- Been thanked: 1 time
Re: Factory drawing cylindre head
Hi, where is the 12g295 head drawing? I couldn't find on the main site or a forum Search. Would you have a link? Thanks
-
5portsrock
- 998 Cooper
- Posts: 559
- Joined: Thu Jun 24, 2010 5:21 pm
- Location: Hampshire
- Has thanked: 9 times
- Been thanked: 1 time
Re: Factory drawing cylindre head
Please ignore me...finger trouble5portsrock wrote: ↑Thu Jan 13, 2022 9:32 pmHi, where is the 12g295 head drawing? I couldn't find on the main site or a forum Search. Would you have a link? Thanks
-
iain1967s
- 1275 Cooper S
- Posts: 1844
- Joined: Sat Jun 10, 2017 12:46 am
- Location: Cambridge, MA, USA
- Been thanked: 7 times
Re: Factory drawing cylindre head
https://mk1-performance-conversions.co. ... rawing.pdf5portsrock wrote: ↑Thu Jan 13, 2022 9:32 pmHi, where is the 12g295 head drawing? I couldn't find on the main site or a forum Search. Would you have a link? Thanks