mk1-forum.net

Switch panel fitted & switches wired ready for fitting heater.
Floor insulation fitted ready for trimming.

looks a great job so far

what carpet are you fitting....veltone?

Thanks.

I am fitting a set from BAS in black veltone, it was the nearest to the original that I could find.

They set is slightly oversize which is good for trimming back to achieve a snug fit.

looks good,

I fitted BAS black veltone in my mk2 998 cooper, very pleased with it, needed a little trimming but was a pretty good fit, also looks correct which is important.

Neat, where did you get the under felt from ?

Thanks.

It's all from Woolies.

Fitted servo and connected pipes today, bleeding brakes tomorrow.

Nice pipe work!

I hope you have more joy with your Servo than I did on the Speedwell car it was pissing brake fluid out within 3 days of being fitted.

Lovely pipe work! Would you make me some up please pretty please

Update on my dogey servo.

It was all down to me. Apparently ALL unions need to be tightened up before bleeding. This appears to be a non optional part of the process!

Strangely enough, my servo works perfectly now!

Brakes sorted now, a couple of minor leaks but no damage done.