Page 2 of 2
Re: 1071 cam?
Posted: Mon Jan 25, 2021 5:26 pm
by Fanfaniracing
Where can i get a 544 or C-AEG643 cam?
Re: 1071 cam?
Posted: Mon Jan 25, 2021 6:53 pm
by swifty
I've got a 1071 fJ engine that i need to build and was thinking about a SW10 . Any thoughts on how that would perform with a big valve head . Twin 1/12 sus on 3.4 diff ... ken
Re: 1071 cam?
Posted: Mon Jan 25, 2021 9:21 pm
by wantafaster1
Fanfaniracing wrote: ↑Mon Jan 25, 2021 5:26 pm
Where can i get a 544 or C-AEG643 cam?
Piper camshafts.
I sold one and the fellow had Piper make him a new one.
Re: 1071 cam?
Posted: Wed Jan 27, 2021 6:52 pm
by CooperTune
I have spent years looking for a clean not cracked 163 casting with nice high seats. Someone spent a lot of time on this head. Bowls nice, guide bosses all but gone ports large enough to concern me at low end. I have a 940 head drilled for 11 and very mildly cleaned up. The old question what correct is most important? Maybe a milder cam would help bottom end and ports allow higher rpm power as well? I have been polishing these things since Sept. 1968 there are combos that really shine. Steve (CTR)
Re: 1071 cam?
Posted: Thu Jan 28, 2021 3:44 pm
by AndyB72
I have an SW8 in my South African 1071, when I finally get it on the road I'll report back but I'm hoping it will be nice and lively but still drivable.