mk1-forum.net

I use this stuff

http://www.henkelna.com/adhesives/produ ... 7960863745

or this stuff

http://www.henkelna.com/adhesives/produ ... 7881991169

Just put it on the tapered seal face, not on the threads and don't use a lot. Tighten normally. Give it about 30 minutes or so before vacuum and fill.

I would only do the joint that is leaking if time is a consideration, you never know what can go wrong when you are pushed for time

I would only do the joint that is leaking if time is a consideration, you never know what can go wrong when you are pushed for time.

Sage words of advice.