Freeflow on Austi moke?

[Charlynsane]

Hello Guys

My father asked me to fit a freeflow+rc40 on his moke,

Is it possible?? it's a 67 moke

What sort of tube should i use? a standard rc40??

than you

Charles

[Spider]

Systems from Minis don't directly fit straight on a Moke. The Extractors / Exhaust Header needs to have a slightly different shape at the lower end and though I think the Engine Pipe (from these to the Muffler) will go on, may need a bit of 'adjusting'. From the RC40 on, will go in no worries.

[Charlynsane]

Hello Spider,

Thank you for your advices

What do you mean? you have to cut it? or to bend it?

I think the lenght is the same?

Thanks

[Spider]

No worries.

The need to be bent a bit tighter where they go under the floor. You'd think they'd be the same as a mini, but they are not.

I'm not sure where you are, but if you are in the UK, I know Maniflow while not stocking the correct Extractors, will make them, though I'm not a 'fan' of Maniflow stuff.

There was a thread on the UK Mini Moke forum recent on this topic but it's down for maintenance just at the moment.

<Edit: Here it is

http://www.mokeclub.org/forum/viewtopic.php?f=8&t=5698 >

[Charlynsane]

Hello Spider,

As for us it's an english car

I took a look to the car, the lenght between the subframes it's the same,

There is no gear linkage, the gear lever is connected direcly on the gearbox, like a 850

so what could be wrong??

thank you

[Spider]

The Firewall is a different shape to a Mini and the floor in the Moke sits about 30 - 40 mm higher.

[Charlynsane]

thank you spider..

I hope I will manage to fit it.. and avoid/cuting/welding

[Spider]

Ah, you may have to cut and bend, but I doubt you'll need to weld anything.

[Charlynsane]

Thank you very much,

I have to lift the engine out before and to paint it, it's a little bit rusty

Thank you for all your advices