Any one know what this bit is?

[minimans]

Both are trim retainers but I must confess I don't recognise them as mini unless there from a late car? Ah! maybe the top ones are fror blanking off the interior light switch holes when not fitted?

[morris cooper]

The two in the top photo are blanking screws for the seat belt fixing in the B post, not sure on the second one though, I've seen something similar before though, might even be a later version of the b post blanks.
Bill

[BRI MK1]

Hi the top picture is plastic seatbelt blanking screws used on early cars without seatbelts fitted, the second picture I think may be boot board clip not sure cheers Brian.

[BRI MK1]

Just come to me some mk1 minis had a boot carpet that covered the boot and also the boot floor itself and these clips were on the boot to hold the carpet think im right.

[Toby]

Both are to blank off the seatbelt fixings in b post and sill. The metal ones are the early type, I think that somewhere around the beginning of 64 they started to use plastic in all fixings. Before that the metal ones were in the b post and were body colour and plastic was used in the sills. The part number for the metal ones is 14A9668, this picture was taken from a June 63 partslist.

[minidean]

Both are to blank off the seatbelt fixings in b post and sill. The metal ones are the early type, I think that somewhere around the beginning of 64 they started to use plastic in all fixings. Before that the metal ones were in the b post and were body colour and plastic was used in the sills. The part number for the metal ones is 14A9668, this picture was taken from a June 63 partslist.

And the winner is, 'mansard'. Thanks for that, its been really puzzling me.

[surfblue63]

Just to confirm what others have said, they are blanks for the seat belt mounts. Here's a shot of the floor showing the plastic one in the sill mounting.



There should be four smaller metal ones which hold the mat to the boot lid. When I got the car it only had one fitted to the boot mat which had a green coloured cap. I found the other three black ones on the Bresco site listed as under dash trim clips on Ford Prefects.

[AustinSuperSeven]

Both are to blank off the seatbelt fixings in b post and sill. The metal ones are the early type, I think that somewhere around the beginning of 64 they started to use plastic in all fixings. Before that the metal ones were in the b post and were body colour and plastic was used in the sills. The part number for the metal ones is 14A9668, this picture was taken from a June 63 partslist.

I've got the plastic type fitted to a late 61 super. They look like they have never been moved.

[mk1]

First ones, seat belt fixing hole blanking plugs (Bottom)

Second one, Seat belt blanking plug (top).

Just discovered I was a bit late on this one As the question was at the bottom of the page, I thought I was first to answer for once. WRONG!

M

[minidean]

Just to confirm what others have said, they are blanks for the seat belt mounts. Here's a shot of the floor showing the plastic one in the sill mounting.



There should be four smaller metal ones which hold the mat to the boot lid. When I got the car it only had one fitted to the boot mat which had a green coloured cap. I found the other three black ones on the Bresco site listed as under dash trim clips on Ford Prefects.

PM Sent, also is there some sort of strip which goes alone the rim in front of the back seat??

[coopertim]

Hi Dean

Yes there should be a light grey plastic strip which fixes onto the lip of metal which retains the rear seat squab. I thought i had found it on Saturday but it was not long enough.

Tim

[surfblue63]

PM Sent, also is there some sort of strip which goes alone the rim in front of the back seat??

Yes, you can see it in the picture I posted.

[Gray]

Also appears on the top of the door aperture lip, probably the shorter length!

[mk1]

Yes there is, its a piece of grey plastic "U" shaped capping that simply clips over the edge of the seat base.

[1071 S]

AUB 662 ??? and, yes, I realise its a fuel pump ....

Cheers, Ian

[rich@minispares.com]

Also appears on the top of the door aperture lip, probably the shorter length!

the door stuff is smaller section than the seat stuff though isn't it?

[mk1]

Off the top of my head I would say that the two bits were the same profile, but without looking I can't be sure.

M

[rich@minispares.com]

ive just actually checked

the seat stuff is 'U' shape, the door stuff is similar, but has one longer 'leg' than the other

[mk1]

Well there you go. We learn something new every day don't we

M

[minidean]

On top of the door aperture???? Sorry I'm still a nooby! Where do you mean???