MK3 WIPER MOTOR ON A MK1

Post any technical questions or queries here.
Post Reply
SMOKE GREY
1275 Cooper S
Posts: 1552
Joined: Thu Jun 24, 2010 7:31 pm
Location: Sunny Lancashire
Been thanked: 2 times

MK3 WIPER MOTOR ON A MK1

Post by SMOKE GREY »

Might be me being thick :) but having just fitted a later round body self motor to the MK1 , how do i get the wipers to park on the RH side as per original or as a LHD MK4/ Rover Mini :?:
66S

Re: MK3 WIPER MOTOR ON A MK1

Post by 66S »

You'll have to change the park position contacts on the gear wheel 180 degs.

Al
User avatar
sandman
998 Cooper
Posts: 582
Joined: Thu Jun 24, 2010 7:24 pm
Location: Langhus, Norway

Re: MK3 WIPER MOTOR ON A MK1

Post by sandman »

Smokey;

Was is easy to fit the round-body wiper motor into the Mk1?
I'm thinking about doing this myself and was sondering if there's anything particular that needs extra attention?

Did you use the original Mk1 wire, tubes and wheel-boxes?
Cheers,

Ed_
User avatar
Spider
1275 Cooper S
Posts: 4805
Joined: Mon May 07, 2012 6:10 am
Location: Big Red, Australia
Has thanked: 125 times
Been thanked: 34 times

Re: MK3 WIPER MOTOR ON A MK1

Post by Spider »

SMOKE GREY wrote:Might be me being thick :) but having just fitted a later round body self motor to the MK1 , how do i get the wipers to park on the RH side as per original or as a LHD MK4/ Rover Mini :?:
Basically the crank pin on the big gear needs to be moved 180 degrees (or it might be 182, can't quite remember). It has the ramp on the back of the gear that activates the park switch. Probably the easiest way would be to get a gear from a LHD Car ;) I would think Mini Spares or Somerfords would have them, but I also suspect that they ain't cheap.
SMOKE GREY
1275 Cooper S
Posts: 1552
Joined: Thu Jun 24, 2010 7:31 pm
Location: Sunny Lancashire
Been thanked: 2 times

Re: MK3 WIPER MOTOR ON A MK1

Post by SMOKE GREY »

66S wrote:You'll have to change the park position contacts on the gear wheel 180 degs.

Al
How do i do this :oops: :?:
GraemeC
1275 Cooper S
Posts: 2275
Joined: Thu Jun 24, 2010 1:05 pm
Location: Hiding From The Dog... NW Eng
Has thanked: 2 times
Been thanked: 3 times

Re: MK3 WIPER MOTOR ON A MK1

Post by GraemeC »

Is there a LHD drive wheel?
I though they mounted the motor on the opposite end of the bulkhead hence which would flip it over and hence 'reverse' the park position.
User avatar
850man
998 Cooper
Posts: 360
Joined: Fri Nov 09, 2012 11:08 am
Location: Melbourne, Australia.

Re: MK3 WIPER MOTOR ON A MK1

Post by 850man »

The last one I did it was a simple case of removing the wheel and swaping the "bump" that triggers the micro switch over to the other side. The bump is removable, it has a pin on the back that pushes into the wheel. There should be a hole for this on the other side. The wiper motor was out of a early 90s Rover Mini.
You will also have to change the wiring and you have the choice of using a change over relay and std Mk 1 mini headlight switch or use a 2 speed wiper switch out of a MGB. (looks the same as a mini headlight switch but switches differently inside)
Smiffy
998 Cooper
Posts: 702
Joined: Fri Jun 25, 2010 10:33 am
Been thanked: 2 times

Re: MK3 WIPER MOTOR ON A MK1

Post by Smiffy »

Post Reply