Am I putting it in the right way.??

[InimiaD]

It must be about 30 years since I watched a guy ream new bushes into some trailing arms for me.

So 30 years later I am fortunate??? enough to own my own Churchill reamer and guide and about to rebuild a pair of rear arms.

Problem is, I am not 100% sure of the correct insertion method with regards as to what end goes where etc.

The guide will only fit in the bearing end and is a nice snug fit. Common sense tells me that the reamer should be inserted from the bearing end.

Am I setting it up the correct way.?? Confirmation gladly received gents.

[JC T ONE]

Am I inserting it correctly.??

Confirmation gladly received gents.

your question made me smile I will not go into details regarding why

[ronie]

The most interesting topic tittle in a log time....

[InimiaD]

I think you could say it's an "attention grabbing headline".

[InimiaD]

I've changed the heading, but I still need to know if I'm doing the job the correct way.?
Has anyone on here done the job before.

Thanks in anticipation.

[bmcman.ie]

stick some hair around it! ian.

[InimiaD]

stick some hair around it! ian.

Tried your advice Ian, but I'm still not 100% sure of the correct way.



Too much hair maybe.?

[bmcman.ie]

he, he, i absolutely love it! but plats in the hair doesnt make it easy, does it! nice one, ian.

[rolesyboy]

When you do figure this out would you midn adding ot to the How to do it section please? Cheers. Mark