wiring loom question

[ronie]

I am finishing the wiring of my 1961 mk1 Mini. I bought a brand new loom, but some of the colours of the cables do not match the wiring diagram, or I do not understand exactly where to connect.

Could you give me a hand?





I also bought some bulbs for the binnacle lights, but I cannot get them to sit in place. The bulb holder also look quite different, compared to the original loom.





What type of bulb should I get?

Thank you.

[surfblue63]

Perhaps this diagram will help





The bunch of black cables with the ring connector need to be grounded to earth.

As for the bulb I would ask the suppler of the loom.

[111Robin]

The bulb is the screw in type. GLB987 from Minispares.

[Jack of all trades]

If the diagram is to difficult to read;
On the voltage regulator;
E has 1 black wire
D has 2 Brown/Yellow wires
F has 1 Brown/Green wire
A has 2 Brown wire
A1 has 2 Brown/Blue wires

The black grounding wire should be attached to the speedo housing (its the grounding for the lights in the speedo)

Jack

[ronie]

Thank you all.

Will attack the loom, with my new found knowledge.