Could anyone tell me the centre to centre dimension between the welded type seat brackets for me please?
Thanks in advance.
Graham
Welded seat brackets dimension
-
Minigman
- 998 Cooper
- Posts: 589
- Joined: Sat Jun 13, 2015 1:41 pm
- Location: North Devon
- Has thanked: 10 times
- Been thanked: 5 times
Welded seat brackets dimension
- You must have shot an awful lot of tigers, Sir.
- Yes, I used a machine gun
- Yes, I used a machine gun
-
CaliforniaMk1
- Basic 850
- Posts: 33
- Joined: Mon Feb 10, 2020 8:02 pm
- Location: Belmont, California, USA
- Been thanked: 6 times
Re: Welded seat brackets dimension
I just did a quick measure across my May-60 shell as below, it's all original floor and box section. I have to say the positioning is not exactly precision, the one next to the tunnel on the left of the car looks like it was late on a Friday! But as I work (too slowly) around my car it reminds me that I don't need to exceed the original built quality, as that's all part of the charm.
Zoom out view to show what I measured.
Individual pics of each one.
Hope this is helpful.
Mike.
Zoom out view to show what I measured.
Individual pics of each one.
Hope this is helpful.
Mike.
-
Minigman
- 998 Cooper
- Posts: 589
- Joined: Sat Jun 13, 2015 1:41 pm
- Location: North Devon
- Has thanked: 10 times
- Been thanked: 5 times
Re: Welded seat brackets dimension
Spot on Mike.
Many thanks for posting the reply.
Many thanks for posting the reply.
- You must have shot an awful lot of tigers, Sir.
- Yes, I used a machine gun
- Yes, I used a machine gun