On A+ 1275 rods, do the tangs on the shell bearings sit on the same side of the rod or opposite sides.
On an A series 1275 block regarding the Mains , same question.
Have a box of bits all disassembled and trying to sort them out.
Thanks
Shell Bearing orientation
-
graham in aus
- 998 Cooper
- Posts: 373
- Joined: Fri Jun 25, 2010 2:17 am
- Location: Australia
Re: Shell Bearing orientation
Normally it's always Tang to Tangm I'm certain it is on rods, but I'm sure there's something odd about one of the mains on an S ?
Just something in the back of my mind.... or maybe I dreamt it!
Where's Simon 251eng, he's probably got six S blocks on his bench right now!!
Just something in the back of my mind.... or maybe I dreamt it!
Where's Simon 251eng, he's probably got six S blocks on his bench right now!!
Mini's don't rust................Downunder!
