Did the "hardware" consist of a short length of rubber (or similar material) on each post, just covering the post?
Or was this only on some Aussie minis?
Now you mention it, I'm sure that the prongs DID have a bit of rubber slipped over the ends. Alas, as soon as the top part was screwed into place, from below, the rubber 'johnnies' tore and you never saw or used them again.
indigo wrote: ↑Sat May 14, 2022 8:09 am
Did the "hardware" consist of a short length of rubber (or similar material) on each post, just covering the post?
Or was this only on some Aussie minis?
Your mean these little pieces? I was thinking of putting some shrink wrap on
the metal posts, might wear better
seat rubber.jpg
You do not have the required permissions to view the files attached to this post.