During disassembly he 3rd/4th synchro hub assy. flew apart. I put it back together but I am not sure the inner hub is right way around. What would happen if it is backwards. The shafts are back in the box with all new bearing,baulk rings but in holding on to input and output they are very stiff. I removed the first motion bearing snap ring and tapped the bearing a bit. They did free up one direction but were a little stiff the other. Is it possible I am worried about nothing?
Thanks Mike
3rd/4th synchro hub
-
floormanager
- 998 Cooper
- Posts: 599
- Joined: Thu Feb 19, 2015 9:16 pm
- Location: Sussex
- Has thanked: 20 times
- Been thanked: 4 times
Re: 3rd/4th synchro hub
Been there!!
Here's a photo
Here's a photo
You do not have the required permissions to view the files attached to this post.