What's this screw for?

Post any technical questions or queries here.
Post Reply
AndyPen
1275 Cooper S
Posts: 3920
Joined: Mon Jul 24, 2017 5:55 pm
Location: South Wales
Has thanked: 18 times
Been thanked: 50 times

What's this screw for?

Post by AndyPen »

After listening to the discussions on earthing the steering rack I was wondering what this screw does? Mk2 rack on my Mk1.

I am sure it is important so I shouldn't remove it - ha ha.


steering-rack-screw.jpg
You do not have the required permissions to view the files attached to this post.
Daz1968
1275 Cooper S
Posts: 1440
Joined: Sat Dec 27, 2014 1:41 pm
Location: Oldbury west midlands

Re: What's this screw for?

Post by Daz1968 »

I think it’s the one that holds the bush in place
User avatar
Spider
1275 Cooper S
Posts: 4851
Joined: Mon May 07, 2012 6:10 am
Location: Big Red, Australia
Has thanked: 186 times
Been thanked: 65 times

Re: What's this screw for?

Post by Spider »

Daz1968 wrote: Thu May 20, 2021 11:27 pm I think it’s the one that holds the bush in place
Yeap, that's it.
User avatar
850man
998 Cooper
Posts: 360
Joined: Fri Nov 09, 2012 11:08 am
Location: Melbourne, Australia.

Re: What's this screw for?

Post by 850man »

The screw holds the bush sleeve in place. The bush is retained by the sleeve, not the screw.
User avatar
850man
998 Cooper
Posts: 360
Joined: Fri Nov 09, 2012 11:08 am
Location: Melbourne, Australia.

Re: What's this screw for?

Post by 850man »

The screw holds the bush sleeve in place. The bush is retained by the sleeve, not the screw.
The steering rack bolts hard against the body of the car, hence it is earthed. But it is irrelevant, being earthed or not has zero effect on its operation, or the horns operation.
AndyPen
1275 Cooper S
Posts: 3920
Joined: Mon Jul 24, 2017 5:55 pm
Location: South Wales
Has thanked: 18 times
Been thanked: 50 times

Re: What's this screw for?

Post by AndyPen »

I've used the plastic straps as you can see, and from my reading the amount of paint on a resto can result in a poor earth, hence I was wondering if this might be a solution? Or should I just earth the column outer and that will solve any issues?
Dearg1275
1275 Cooper S
Posts: 1501
Joined: Mon May 11, 2015 4:16 pm
Location: Scotland

Re: What's this screw for?

Post by Dearg1275 »

On mk1s the horn earths via the inner column by way of the steering rack. The indicator warning bulb earths via the outer column. If either inner or outer are not making a good earth problems will happen.

Before you go adding earth straps to the steering rack check out the Bakelite horn carrier. The brass bridging strap and screw post contact can corrode to the point that enough current won’t pass. It’s easy to test. Just make a temporary earth by touching the retaining screw with an earthed cable and sounding the horn. Noise = earth failure somewhere down the inner column. No noise = some resistance before this (or both).

Electrics, don’t you love them?

D
Post Reply