Post any technical questions or queries here.
SMOKE GREY
1275 Cooper S
Posts: 1552 Joined: Thu Jun 24, 2010 7:31 pm
Location: Sunny Lancashire
Been thanked: 2 times
Post
by SMOKE GREY » Thu Dec 01, 2011 12:18 pm
Anyone know the lucas number for the correct switch for the early heater, or anyone got a new one
mk1
Site Admin
Posts: 19846 Joined: Thu Jun 24, 2010 11:30 am
Location: Away with the Faries
Has thanked: 3 times
Been thanked: 8 times
Post
by mk1 » Thu Dec 01, 2011 4:41 pm
I'll have a look, I may still have one.
Watch this space.
mk1
Site Admin
Posts: 19846 Joined: Thu Jun 24, 2010 11:30 am
Location: Away with the Faries
Has thanked: 3 times
Been thanked: 8 times
Post
by mk1 » Fri Dec 02, 2011 8:10 am
Checked last night, found it, checked it. Didn't work.
Sorry.
SMOKE GREY
1275 Cooper S
Posts: 1552 Joined: Thu Jun 24, 2010 7:31 pm
Location: Sunny Lancashire
Been thanked: 2 times
Post
by SMOKE GREY » Fri Dec 02, 2011 8:16 am
mk1 wrote: Checked last night, found it, checked it. Didn't work.
Sorry.
Cheers for looking Mark.
HuwGreenMiniVan
Post
by HuwGreenMiniVan » Sat Dec 03, 2011 11:32 pm
These were fitted on Mini vans and pickups as standard well into the late 1960's. My 1968 Mini Van had one. So look out for any scrapped ones from around then for one.
HuwGreenMiniVan
Post
by HuwGreenMiniVan » Sun Dec 04, 2011 12:10 am
As an aside, Mini vans and pick-ups then had the heater brass tap at the end of the cylinder head as well, so grab that as well if you find one scrapped....
814CWE
998 Cooper
Posts: 712 Joined: Fri Jun 25, 2010 1:24 pm
Location: in my workshop
Post
by 814CWE » Tue Dec 06, 2011 5:31 pm
same as early mg and sprites
rimmer bros
for my sins,i own a 1957 wolsleley 1500
Ronnie
1275 Cooper S
Posts: 1266 Joined: Fri Jun 25, 2010 5:37 pm
Location: N/E England Where the SAND is GOLDEN and the sea is always COLD!!
Has thanked: 6 times
Been thanked: 19 times
Post
by Ronnie » Tue Dec 06, 2011 10:09 pm
I don't think they are all the same you can get different resistances.
814CWE
998 Cooper
Posts: 712 Joined: Fri Jun 25, 2010 1:24 pm
Location: in my workshop
Post
by 814CWE » Thu Dec 08, 2011 10:50 pm
all work ok tho
for my sins,i own a 1957 wolsleley 1500