Page 1 of 1
Gear shift blanking panel question
Posted: Wed Nov 13, 2013 10:58 am
by ChrisM
I am about to re-fit the blanking panel and I vaguely remember having to drill out the screws that secured it. Does anyone have the size of these? I would have thought a short dome head Phillips type?
Re: Gear shift blanking panel question
Posted: Fri Nov 22, 2013 9:13 am
by ChrisM
Can anybody tell me what a PTZ804 screw is? From AKD3510 BA1.2
Re: Gear shift blanking panel question
Posted: Fri Nov 22, 2013 9:38 am
by rich@minispares.com
its a number 8 1/2" long screw
you could use a gfk2258
Re: Gear shift blanking panel question
Posted: Fri Nov 22, 2013 10:08 am
by ChrisM
Rich - you splendid chap. That is spot on.
Cheers - Chris.
Re: Gear shift blanking panel question
Posted: Fri Nov 22, 2013 6:46 pm
by Tim
P=pan head
T=self tapper
Z=zinc plated
8=8ga
04=4/8 or 1/2"