Page 1 of 1
Churchill rubber cone compression tool modifiactaion
Posted: Fri Feb 08, 2013 9:26 am
by sandman
Has anyone modified the original churchill suspension compression tool to go with the new metric rubber cones?
(or better yet make it possible to swap between UNF and metric threaded splines)
Re: Churchill rubber cone compression tool modifiactaion
Posted: Fri Feb 08, 2013 10:09 am
by Smiffy
Proper ones have both imperial and metric adapters.........
Re: Churchill rubber cone compression tool modifiactaion
Posted: Fri Feb 08, 2013 10:16 am
by guru_1071
mine has both adaptors
the ones from the early proper sykes picakvant ones fit the churchill tool as well, these are often on ebay
http://www.ebay.co.uk/itm/Sykes-Pickava ... 416f779710
Re: Churchill rubber cone compression tool modifiactaion
Posted: Fri Feb 08, 2013 11:42 am
by mk1
Ditto, mine also has both thread options.
Re: Churchill rubber cone compression tool modifiactaion
Posted: Sat Feb 09, 2013 2:12 am
by Spider
I have an M14 long (very long!) tap which I run though them
and a hydraulic compressor
