mk1-forum.net

Is this fixable in any way or just for the bin?
Apart from the broken handle - the switch is fine.... anyone that restore these?

ive repaired these with epoxy resin and sanded them to a mirror smooth finish
a coat of black on the freshly repaired end,,good as new,,,,well,,good enough

Is it possible to remove/ switch the stalk with another from a broken switch?

sometimes yes sometimes no

I did that also, and I bought one of these:

http://www.ebay.co.uk/itm/MORRIS-MINOR- ... 2db&_uhb=1

I don't know if they are same as original or not, but I made the newly epoxyed lever fit that lense

Frogeye61 wrote:I did that also, and I bought one of these:

http://www.ebay.co.uk/itm/MORRIS-MINOR- ... 2db&_uhb=1

I don't know if they are same as original or not, but I made the newly epoxyed lever fit that lense

Yep,did the same. The end was 'epoxy-ed' in but you get at least 1 bulb's life out of it. These sort of repairs are quite satisfying when they go right,a whole lot more enjoyable than slapping on a modern repro anyhoo !

Minimania.com sells a repair kit. Part # is Rep01

Great - thanks!