mk1-forum.net

It must be about 30 years since I watched a guy ream new bushes into some trailing arms for me.

So 30 years later I am fortunate??? enough to own my own Churchill reamer and guide and about to rebuild a pair of rear arms.

Problem is, I am not 100% sure of the correct insertion method with regards as to what end goes where etc.

The guide will only fit in the bearing end and is a nice snug fit. Common sense tells me that the reamer should be inserted from the bearing end.

Am I setting it up the correct way.?? Confirmation gladly received gents.

InimiaD wrote:

Am I inserting it correctly.??

Confirmation gladly received gents.

your question made me smile I will not go into details regarding why

The most interesting topic tittle in a log time....

I think you could say it's an "attention grabbing headline".

I've changed the heading, but I still need to know if I'm doing the job the correct way.?
Has anyone on here done the job before.

Thanks in anticipation.

stick some hair around it! ian.

bmcman.ie wrote:stick some hair around it! ian.

Tried your advice Ian, but I'm still not 100% sure of the correct way.



Too much hair maybe.?

he, he, i absolutely love it! but plats in the hair doesnt make it easy, does it! nice one, ian.

When you do figure this out would you midn adding ot to the How to do it section please? Cheers. Mark