Page 1 of 1
Tappet chest cover - convex or concave
Posted: Sun Sep 23, 2012 12:48 pm
by timo
I am in the process of digging out all the bits for my '66 1275 S resto. I have the tapet chest cover with the oil trap which is concave in shape, which is what I would have expected, but the other cover is concave - should this be the case or should that too be convex. The car was made in Nov '65
Thanks
Mike
Re: Tappet chest cover - convex or concave
Posted: Thu Sep 27, 2012 6:07 am
by KA2S4
Hi Mike, I think you may have made a typo,
did you mean to say your cover with breather is concave or convex?
As far as i know, early ones are convex with no return around the edge to help locate the gasket, late ones like yours are concave and have the return round the outside to locate the gasket.
James.
1071Bob, calling 1071Bob...
Re: Tappet chest cover - convex or concave
Posted: Thu Sep 27, 2012 8:52 am
by timo
Thanks James
I will double check when I get back home, but from what you say, they should both be the same - i.e concave
Cheers
Mike
Re: Tappet chest cover - convex or concave
Posted: Fri Sep 28, 2012 8:35 pm
by NickD
The convex covers (with cork gaskets) were used on the 1275S up until about January 1966. From engine number 9F/SA/Y40006 they were replaced by the concave covers and rubber gaskets.
Re: Tappet chest cover - convex or concave
Posted: Fri Sep 28, 2012 9:31 pm
by timo
Thanks NickD, mine was made in Nov 65 but not registered until May 66, so it will be the cork ones then
Cheers
Mike