Page 1 of 1
ARP Head bolts What torque setting please
Posted: Mon Jul 09, 2012 3:08 pm
by rolesyboy
Hi All. Does anybody have a figure for tightening down ARP Head bolts please? Can't seem to find anything relating to this and my mate has a very weepy cylinder head post rebuild. Any advice appreciated. Thanks in advance. Mark
Re: ARP Head bolts What torque setting please
Posted: Mon Jul 09, 2012 3:18 pm
by cheleker
60 lb.ft. with 30 wt oil. 40 with ARP lube.
Front stud on 11 stud head is 30 or 20.
Front bolt on 10/1 head is 33 or 22
Re: ARP Head bolts What torque setting please
Posted: Mon Jul 09, 2012 11:28 pm
by Red1967
Stretch them as well. Torque them up. Then loosen them. Repeat three times. When you loosen them make sure you reverse the pattern of tightening.