Page 1 of 1
Early Oil Coolers
Posted: Tue Jan 31, 2012 1:01 pm
by Pete
Can't quite remember now from previous discussions about this whether anyone was yet reproducing pipes and or brackets for the upright oil cooler ? 1071 Bob ?
Re: Early Oil Coolers
Posted: Tue Jan 31, 2012 4:45 pm
by IAIN
and another while on this subject,
Mr 1071 Bob, do you make the bracket to hold the PCL valve to the inlet manifold ?
Re: Early Oil Coolers
Posted: Tue Jan 31, 2012 4:53 pm
by Gray
IAIN wrote:and another while on this subject,
Mr 1071 Bob, do you make the bracket to hold the PCL valve to the inlet manifold ?
minispares do them I believe.
Re: Early Oil Coolers
Posted: Tue Jan 31, 2012 8:02 pm
by ricardo
I think Bob makes the plates (one for each side), both brackets and was trying to replicate the pipes. As far as I know, no one is reproducing the cooler. Maybe another MS north project, Rich?
This cooler was sold recently as a vertical oil cooler, but it isn't, it is the later horizontal type. Vertical coolers are much smaller!
Re: Early Oil Coolers
Posted: Tue Jan 31, 2012 9:04 pm
by Pete
Bloody hell that doesn't look anything like the upright cooler. I've got a couple but no pipes, hence the question.
Re: Early Oil Coolers
Posted: Tue Jan 31, 2012 9:26 pm
by Mini4Ever
Bob is producing the brackets and pipes for the early vertical oil coolers. His details are here:
viewtopic.php?f=9&t=38
Re: Early Oil Coolers
Posted: Wed Feb 01, 2012 10:29 am
by Pete
Thanks Bart, I was unsure about the pipes. I had some made about twenty years ago copied from an original set, wish I'd had a dozen done now !
Cheers.