Power by Morris Motors
Posted: Mon Mar 27, 2023 5:51 pm
Hi
Possibly posted before but still a good watch…
https://youtu.be/ieF3d_YBUh4
When it comes to pins my own experience at Wellworthy was we used auto bar feed lathes and gun drilled the bores then parted off, ground the ends, heat treatment, then passed down a line of 6 centreless grinders to final size and finish, no lapping required…
Possibly posted before but still a good watch…
https://youtu.be/ieF3d_YBUh4
When it comes to pins my own experience at Wellworthy was we used auto bar feed lathes and gun drilled the bores then parted off, ground the ends, heat treatment, then passed down a line of 6 centreless grinders to final size and finish, no lapping required…
