mk1-forum.net

Posted: **Tue Feb 15, 2022 11:29 pm**

As per title, about to remove Dynamo to replace front(pulley end ) bearing. Is it a difficult job ? Any advice much appreciated,thanks

Posted: **Wed Feb 16, 2022 6:48 am**

I've done a few. It's not hard. Drill the rivets out and away you go.

Posted: **Wed Feb 16, 2022 7:38 am**

Thanks for the advice.

Posted: **Wed Feb 16, 2022 9:26 am**

When bearing replaced, put Dynamo to one side and replace with an ACR. VERY simple and inexpensive job

Posted: **Wed Feb 16, 2022 5:35 pm**

What’s a ACR ?

Posted: **Wed Feb 16, 2022 6:03 pm**

Alternator

Posted: **Wed Feb 16, 2022 6:22 pm**

GraemeC wrote: ↑Wed Feb 16, 2022 6:03 pmAlternator

Devil's generator

Lucas dynamo bearing change