mk1-forum.net

Hi people,

I have finally signed on after lurking for a while, loads of people with great knowledge here!

I have got a minispares race LSD that I receive in bits.

I am not sure how it all goes together, but I think I might have figured it out.

Also I do not know how to investigate if parts are worn, any ideas? I guess the ramp is scrap (as can be seen from the picture below) or is it useable? I do not know which part that actually get worn in these.

Pictures:







Is this the correct order?





Many thanks for any help!

no one able to help me with this? in the first picture of the total assembly there is one piece not visible in the picture as it it hidden behind the differential housing. it is the same piece as the others with a bulged outside edge.

rich is youre man to ask.

the way you have it layed out looks fine, just look at the preload washer and see wich way it will work best, ie taper pointing in or out.

is that a bit of a nasty chip on that ramp ??

all in all looks quite a good way how they have located the ramp on splines. its as they say, a well refined salisbury.

my quaife ATB is a tad snatchy for my likeing so i was thinking to going to the mini spares one.

yes, it has a bit broken off, so I guess I need a new ramp.

Thanks for helping!