DR3 Wiper motor bolt / thread size ??
Posted: Sat Jun 20, 2020 7:20 pm
The 2 long bolts ( approximately 3 1/2" long ) that hold the DR3 wiper motors together...
What is the thread size ?? Need to clean the threads of the bolts and the threaded holes in the top housing.
I have tried a 10 X 32 die but that is not correct. Are these a British thread ?
Also, the screws that hold the cover....thread size ??
Thanks for the assistance!
Jim
What is the thread size ?? Need to clean the threads of the bolts and the threaded holes in the top housing.
I have tried a 10 X 32 die but that is not correct. Are these a British thread ?
Also, the screws that hold the cover....thread size ??
Thanks for the assistance!
Jim