Page 1 of 1
Kent Camshaft question
Posted: Fri Dec 27, 2019 6:08 pm
by almondgreen
Has anyone heard about a KENT 366 MD camshaft?
Re: Kent Camshaft question
Posted: Fri Dec 27, 2019 6:39 pm
by Oneball
Re: Kent Camshaft question
Posted: Fri Dec 27, 2019 6:55 pm
by almondgreen
366 not 266
Re: Kent Camshaft question
Posted: Fri Dec 27, 2019 7:25 pm
by LarryLebel
366 is more degrees than a circle, so likely a mislabel, possibly a joke.
Re: Kent Camshaft question
Posted: Fri Dec 27, 2019 8:44 pm
by Hipwell
Sounds a mistake.
Call them up and ask them.
Re: Kent Camshaft question
Posted: Fri Dec 27, 2019 9:57 pm
by wantafaster1
649 is nearly two circles but they still run.
Bound to be 266
Re: Kent Camshaft question
Posted: Sat Dec 28, 2019 2:53 am
by smithyrc30
A four stroke engine has 720 degrees in a cycle so even with 366 degrees of cam period, there are still 354 where the valve is closed (less the opening ramps of course)
Re: Kent Camshaft question
Posted: Sat Dec 28, 2019 6:41 am
by Spider
Measure it. If you have the basic gear for dialing a Cam in on a build, then you can measure what the cam profile is.
