Page 1 of 1
Copper heater hose
Posted: Fri Dec 13, 2019 4:34 pm
by roymck
Found who sells these the other week but now for the life of me I can’t find it again .
It’s the U shaped rubber hose and the copper heater pipe that runs in front of the rocker cover as per this picture . So who sells these ?
A6331997-399C-4A36-9DE6-E9802730D8FD.jpeg
Re: Copper heater hose
Posted: Fri Dec 13, 2019 4:49 pm
by Rusty old S
Gordon , aka catmint , look on recommend suppliers section
Re: Copper heater hose
Posted: Fri Dec 13, 2019 5:04 pm
by swifty
What a absolutely stunning engine bay ....
.... ken
Re: Copper heater hose
Posted: Fri Dec 13, 2019 5:24 pm
by jay weinstein
swifty wrote:What a absolutely stunning engine bay ....
.... ken
I agree. Who owns it?
Re: Copper heater hose
Posted: Fri Dec 13, 2019 5:24 pm
by roymck
Rusty old S wrote:Gordon , aka catmint , look on recommend suppliers section
Yes that’s the guy . Thanks Roy
Re: Copper heater hose
Posted: Fri Dec 13, 2019 5:32 pm
by roymck
jay weinstein wrote:swifty wrote:What a absolutely stunning engine bay ....
.... ken
I agree. Who owns it?
Found the picture on here , did it belong to a guy called Swifty ?
Re: Copper heater hose
Posted: Fri Dec 13, 2019 7:30 pm
by Fanfaniracing
Is this a seven port?
Re: Copper heater hose
Posted: Fri Dec 13, 2019 7:59 pm
by Charlynsane
No looks like split weber
About your car if you are LHD it's a different copper hose
Take a look on my 997 thread
Re: Copper heater hose
Posted: Fri Dec 13, 2019 8:33 pm
by swifty
Yes it was one of my old minis . I was being sarcastic
... I built the car a few years ago but that's well known on this forum . Charles it's a Manx 7 port . Twin not split 45s ... ken
Re: Copper heater hose
Posted: Sun Dec 22, 2019 6:55 pm
by DUF2 ‘65 Elf
The pipe & hose should be available from any friendly plumber, that should be dead easy to make up.
If I was doing that, rather than have the hose with the 180 bend onto the heater tap, I would be using two 15mm Yorkshire elbows and just a short straight hose.