Page 1 of 1
UHR850 gearstick question
Posted: Fri May 13, 2011 10:40 am
by UHR850
Hi, can someone tell me where the extra "pullstick" beside the gearstick was ment for ?
http://excoboard.com/forums/13326/user/ ... 322603.jpg
Thanks,
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 10:55 am
by greyghost
could it be a reverse lock-out.
as it seems to be quite attached to gear lever and going down that side of the hole?????
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 11:13 am
by guru_1071
ditto
it will go into the hole in the front of the box where the reverse light could go, you will have to pull the twagger to lift the detent plunger so that it will go into reverse
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 11:14 am
by 59fan
Good man! I've been looking for a decent picture of one of these for ages, it is a reverse gear lockout and I need to find or fabricate one.
Ian
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 11:41 am
by UHR850
Thanks guys, the picture came from the internet !
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 12:06 pm
by guru_1071
59fan wrote:Good man! I've been looking for a decent picture of one of these for ages, it is a reverse gear lockout and I need to find or fabricate one.
Ian
i bought mine from youles racing - very nice bit of kit (doesnt look like the one in the downton car, but does the same job)
Re: UHR850 gearstick question
Posted: Fri May 13, 2011 12:12 pm
by 59fan
Is that Mike Youles? The website seems to be down.
If it is Mike I'll see if I can catch him at Caburn Classics.
Thanks for the tip.
Ian
