Page 1 of 1
Removing Remote Gearbox Change Shaft Bushes
Posted: Thu Jul 12, 2018 4:10 pm
by Lakeland997
The bronze ones in the Diff housing... any advice?
Puller or knock them out from behind with a punch?
Andy
Re: Removing Remote Gearbox Change Shaft Bushes
Posted: Thu Jul 12, 2018 4:21 pm
by abs
I have done a couple with a long thin drift. I gently warmed the alloy case first then got the hammer out.
Once the bottom one is out the top can be got with a better diameter drift.
Re: Removing Remote Gearbox Change Shaft Bushes
Posted: Thu Jul 12, 2018 4:28 pm
by rich@minispares.com
Re: Removing Remote Gearbox Change Shaft Bushes
Posted: Thu Jul 12, 2018 5:24 pm
by Lakeland997
Thanks chaps.
Managed to drift them out with a nice piece of steel bar.
Re: Removing Remote Gearbox Change Shaft Bushes
Posted: Thu Jul 12, 2018 7:27 pm
by swifty
You can also use part of a rubber cone suspension tool . I use course thread . Photos self explanatory.. ken
Re: Removing Remote Gearbox Change Shaft Bushes
Posted: Tue Dec 29, 2020 8:18 pm
by swifty
Hopefully this will explain . Found on one of my old posts ... ken