mk1-forum.net

Here I am , stranded as the foolest of the fools... I am ready to rebuild a group of early mk1 Lockheed servos, just back from the cad plater, with new seals, gaskets etc. I have the whole caboodle of bits and pieces, but cannot remember HOW they all fit together. I know, I know.... I should have been taking notes, and pictures when taking them apart. But that happened such a long time ago, that I don't care to remember. I went trawling thru Google, at no avail. Anybody has a good exploded scheme?

try this one
can´t find an english version at the moment....

http://www.miniminor.com/dcm/cat_ric/man_mk1_2/ae.pdf

I cannot believe some people on this forum. Fancy dismantling something as complicated and as valuable as that without photographic records...
Coincidentally I have a friend, ahem, who did the very same thing and I am sure he (or she???) will be hugely grateful when he has to do the same job he has been putting off since I (oops!) did the same thing twelve years ago
Thanks for adding this diagram. If anybody has one in English it would be really helpful
What was the conclusion on cad plating a Mk 1 servo in the end? Mine has been painted 2 pack black and I would like to restore to original spec. Cheers. Mark

The exploded drawing can be found in AKD 3509, of which can be found on this site.

I am quite a dumb@ss... I have the AKD3509 here, just copied the page to bring it in the garage....., Better yet, will bring it to the copier to have it in A3! My eyes are'nt that good anymore! Thanks, guys!

Paul, where are you located in Italy? I am in Florence for the next few weeks. Can help if you need

Hi Ricardo, I am in Milano, but my cars are spread everywhere I have a trusting friend with a garage.... And all the spares are near Genova, where I go on the weekends. Not an easy hobby.....