mk1-forum.net

Hi,

I need your help to identify the correct location of the ignition coil for an Mk1 Morris Traveller built in early May 1961.
Is the correct location:

a: on the clutch side as the early Minis had it (as seen here: http://mk1-performance-conversions.co.u ... g_59_1.jpg)
or
b: positioned with a bracket on the C40 dyno (as seen here: http://mk1-performance-conversions.co.u ... eg_002.jpg?

I am grateful for your expert advise.

Best regards
Lupo

if its a floor start solenoid then as first pic, if solenoid mounted on the flywheel housing then coil would be on the dynamo with a bracket

Daz1968 wrote:if its a floor start solenoid then as first pic, if solenoid mounted on the flywheel housing then coil would be on the dynamo with a bracket

Thanks for the rapid response.
This Mini has a floor mounted solenoid.

Regards
Lupo