Page 1 of 1
Replacing inner and outer A panels
Posted: Thu Jan 14, 2016 4:11 pm
by mister bridger
Hi folks, this is a job I'm going to have to tackle soon, hopefully without also replacing the wings. Is there a how to guide/thread on this anywhere? For instance, would you weld the inner to the outer first, or mount them one at a time? Only ever done mk3 ones before!
Re: Replacing inner and outer A panels
Posted: Fri Jan 15, 2016 5:53 am
by swindrum
I have just finished doing this on my Countryman project. I used repro inners and outers and getting them to fit was a real bear. The last car I did I used M machine panels and it went much more smoothly.
Not a tutorial, but I have photos in this thread if it helps...
viewtopic.php?f=6&t=13886&start=50