mk1-forum.net

Hi all,

I managed to get my hands on a Halda Speedpilot Mk IV. I'm a complete noob to these and was considering selling it on, but I started reading up and am wondering what T-gears are used to fit these to a Mini? The unit came with a "gearbox" screwed onto the back of it that says 7.5:1 on it. It also came with a T-gear that has V14 and 8:1 on it. I assume one needs a short length of cable to connect between the speedo and the T to remove it slightly back from the tight area in the binnacle right behind the speedo?

Basically I'd like to know which T gears and cables people use to fit these to a Mini.

Thanks for any advice

Try this guy = http://www.donbarrow.co.uk/halda_haldas_tripmeters.html

Real halda bits look very pricey... How ever speedy cables seem to be able to make up junction boxes and cables with different ends. That's my plan for when I get it installed..

You need a v12 for a mini plus the other 7.5:1 drive.

Thanks for the reply. I have V16 to swap for a V12 then if anyone is interested.