mk1-forum.net

Hello!
I have four quick questions because today i have to finish welding on my project because i am loosing rented space in workshop, So i need help urgently.
I hope you will be able to find out what i mean because my english is not so good and it is very difficult for me to explain in foreign language what i need regarding welding the panels.

my first question:
Can any one help me with suggestion orproper photo to see how the welding of outer sill with subframe mounting rear panel should be. i hope anyone can help me if that position is correct?


second question is:
How it should be looking original welding on the bracket and sill? any good photo to see it?


my third question:
I had to change a part of subframe mounting rear panel and i have to make a holes for fixing a radius arm shroud. does any one can suggest me how I have to do properly or any photo if i have to weld a nut and where it should be?


The last question:
My floor to sill reinforcement bracket were totay rusted, so i have to change them too. i would appreciate if you can share any photo how it was looking after fixing them.


Thank you for help to every one in advance.

You should find a few helpful tips in this old thread.

viewtopic.php?t=11281

Bob's pictures on the other thread should be the best help but here's a picture I took of my car which apart from a repaint was completely original - no welding/repairs in this area - so shows what the finished job should look like.