Page 1 of 1
A+ gearbox final drive query
Posted: Fri May 08, 2015 1:48 pm
by cookie1071
anyone know what final drive is likely to be fitted to a DAM 4818 box? or are there likely to be loads of possibilities?
Re: A+ gearbox final drive query
Posted: Fri May 08, 2015 1:55 pm
by rich@minispares.com
no 100% answer
id guess between a 3.6 and a 3.1
I think its too early to have seen a 2.7 or a 2.9
but too late to have seen any of the really low stuff like 4.1 etc
Re: A+ gearbox final drive query
Posted: Fri May 08, 2015 6:36 pm
by cookie1071
Ok cheers muchly
Re: A+ gearbox final drive query
Posted: Fri May 08, 2015 11:01 pm
by LuisM
I've put at least two into bits, they were both 3.44 from 10" wheeled 998's, they have A+ layshaft, mainshaft and idler gear, the teeth profile and ratio is Pre A+ though.
Not sure if they were also fitted to early metros with 3.65 final drive.
Cheers
Luis
Re: A+ gearbox final drive query
Posted: Thu May 14, 2015 6:18 am
by Spider
All the DAM4818 we had here were fitted with 4.2's only.