Twin Hs2 Carb Issues
Posted: Tue Apr 21, 2015 9:29 pm
Evening Lads
Right I'm building my twin carbs up ready to go on the engine. Now I'll be supercharging the engine in the furutre but for now I want some old skool cool with the lovely tune of twin carbs
Issue I'm having is with the Linkage.
The Carbs come off a mark 3 Sprite but i've brought:
Minispares Inlet
Minispares Heat shield
Minispares 5mm spacers
float blow angle rubbers
so building them up my issue lies with this part
On top of the leaver that moves the shaft to do the butterfly the Top small hole should take the spring to keep it shut. I take it Mini ones are different to this then?
thanks
Stephen
Right I'm building my twin carbs up ready to go on the engine. Now I'll be supercharging the engine in the furutre but for now I want some old skool cool with the lovely tune of twin carbs
Issue I'm having is with the Linkage.
The Carbs come off a mark 3 Sprite but i've brought:
Minispares Inlet
Minispares Heat shield
Minispares 5mm spacers
float blow angle rubbers
so building them up my issue lies with this part
On top of the leaver that moves the shaft to do the butterfly the Top small hole should take the spring to keep it shut. I take it Mini ones are different to this then?
thanks
Stephen