mk1-forum.net

Hi

I have an a series head fully modified with a 201 casting any ideas where a 201was fitted

Thanks

Trevor

I don't see a 201 but there is a 202.....

http://www.calverst.com/articles/ch-cyl ... _%20no.htm



Craig

Craig
Thanks for response and list but definitely a 201 cast in head under the rockers may be a inline head so modified can't tell

Trevor

If I recall they may have been fitted on some of the South African Cars and maybe some of the Innocenti's. They were similar to a 202 casting but for a 998 fitted with flat tops (or raised D's????) and so had a different combustion chamber capacity.

PS, I'd express some caution if working from any of Calver's info.

Spider wrote:If I recall they may have been fitted on some of the South African Cars and maybe some of the Innocenti's. They were similar to a 202 casting but for a 998 fitted with flat tops (or raised D's????) and so had a different combustion chamber capacity.

PS, I'd express some caution if working from any of Calver's info.

That sounds right...

http://www.minispares.com/product/classic/12G201N.aspx

Thanks guys that seems to clear that up well done

Regards

Trevor

timmy201 wrote:

Spider wrote:If I recall they may have been fitted on some of the South African Cars and maybe some of the Innocenti's. They were similar to a 202 casting but for a 998 fitted with flat tops (or raised D's????) and so had a different combustion chamber capacity.

PS, I'd express some caution if working from any of Calver's info.

That sounds right...

http://www.minispares.com/product/classic/12G201N.aspx

Ha, well, there you go, but seems not fitted to the South African cars and only with flat tops. Nice find.

Is that a head from spain ?