Page 1 of 1
1071 Rods
Posted: Wed Nov 03, 2010 8:28 am
by towners
I have bought a load of bits recently and included are a set of conrods and pistons, they have had 1071 written on one piston but
the casting numbers are really worn.
Anyone know any other way i can check if they are 1071? will post a pic on here tonight
There was also a S crank aeg171 which I understand is also 1071 so Im hopefully the rods are also
P
Re: 1071 Rods
Posted: Wed Nov 03, 2010 8:31 am
by Vegard
1071 and 1275 rods are the same. If you measure the length of them you can easily exclude the fact if they are 970 ones.
Re: 1071 Rods
Posted: Thu Nov 04, 2010 8:12 am
by towners
They are 19cm long approx
apogologies for pic - phone camera in a shed at 6.50am this morn
Re: 1071 Rods
Posted: Thu Nov 04, 2010 8:16 am
by Vegard
Where do you measure 19cm?
Re: 1071 Rods
Posted: Thu Nov 04, 2010 8:30 am
by towners
Vegard
From top (approx from gudgeon pin end) to bottom although now im awake it seems incorrect!
P
Re: 1071 Rods
Posted: Thu Nov 04, 2010 8:52 am
by Vegard
I guess others could help, but if not I'll measure the 970/1071 ones I've got this weekend.
Re: 1071 Rods
Posted: Thu Nov 04, 2010 9:05 am
by towners
Cheers Vegard
Re: 1071 Rods
Posted: Thu Nov 04, 2010 8:33 pm
by towners
remeasured from centre of both holes 5 3/4 inches
can just make out aeg 177 so think they are 1071
p
Re: 1071 Rods
Posted: Thu Nov 04, 2010 10:27 pm
by 1071bob
AEG 177 conrods can be 1071 or 970. the 970 conrods are 5.875 centres and the 1071s are 5.75 centres.
