Page 1 of 1

Wiper switch wiring

Posted: Tue Oct 14, 2014 7:11 pm
by tedmcedd
Right.

I'm trying to wire some 2 speed wipers from a twin stalk column to a toggle switch...

Looking in the haynes, there is a diagram for a 2 speed option on the cooper S and GT etc. Would I be able to use a lucas headlamp 2 position switch to do this? or was it a specific switch for wipers??

Anyone done this!?

Ed

Re: Wiper switch wiring

Posted: Tue Oct 14, 2014 7:37 pm
by ianh1968
When you switch the wipers "off", you are actually switching the
power from "slow" to "park", so a headlamp switch will not work...

When it is switched to "park", the motor keeps going until the
"ramp switch" in the motor itself turns it off. This switch also
shorts the two sides of the motor together which causes it
to stop abruptly and not run on-and-on etc.

It could be made to work with a relay, but if you have the correct
switch, things are easier.

I have done this with a Lucas toggle switch and no relay on one
of my cars. Unfortunately it has since been "undone"...

Does this help?
WiperWiring.jpg
Ian

Re: Wiper switch wiring

Posted: Tue Oct 14, 2014 8:32 pm
by tedmcedd
That looks very helpful! My brain isn't properly functioning this evening! but Im sure it makes sense! looks to explain which colours should be togther at any one time...

Many thanks! I'll read it a few times...!

Re: Wiper switch wiring

Posted: Tue Oct 14, 2014 9:03 pm
by InimiaD
A MK 3 Mini owner I know has a 2 speed wiper in his car and he is adamant it is as it left the factory. He's on the look out for a new switch, 2 speed, because his is kaput.
I reckon the switch he needs would have been used on a Leyland vehicle of the same age. MGB perhaps.?

Re: Wiper switch wiring

Posted: Tue Oct 14, 2014 10:01 pm
by tedmcedd
Yes,

I have just bought this:

http://www.ebay.co.uk/itm/Lucas-35927-5 ... 35d6f260eb

Hopefully I will be able to work it out with the diagram above!


It shows in the haynes as an option on the wiring diagram, as does hazards!

Re: Wiper switch wiring

Posted: Wed Oct 15, 2014 3:27 am
by dklawson
As above, you need a 2-speed wiper switch. You can operate the 2-speed motor using an on-off-on toggle switch but the switch has to control two relays to make the circuit work. I wired such a setup last year on a budget race car. The schematic is online. See the link below.
http://www.vitessesteve.co.uk/assets/image002.gif

Re: Wiper switch wiring

Posted: Wed Oct 15, 2014 7:49 am
by LuisM
Hi
the 2 speed wiper switch available is BMC part number BHA4786 , used in the MGB's.
You could use a lights switch, but you would have to train a bit at parking the wipers :)

Regards
Luis

Re: Wiper switch wiring

Posted: Wed Oct 15, 2014 9:36 am
by Smiffy