Page 4 of 4
Re: At my wits end, again!
Posted: Mon Jul 29, 2024 1:06 pm
by CooperTune
It has been quite awhile since I machines a 998 block for 1275 valve pockets. I also drill mine for the extra head studs. I seem to recall using the 1275 gasket and having to plug and drill a cooling passage to match gasket and head? Steve (CTR)
Re: At my wits end, again!
Posted: Thu Aug 01, 2024 7:19 pm
by Jasonking
New question! Ready to reassemble head, which head gasket to use……? The Victor Reinz composite one, or the uprated Minispares copper jobby, or their lower spec copper oe gasket? Also with Wellseal or not? Mmmmmmm?
Re: At my wits end, again!
Posted: Sat Aug 03, 2024 4:40 pm
by InnoCooperExport
I think the Victor Reinz ones are quite well rated.
Re: At my wits end, again!
Posted: Sat Aug 03, 2024 6:28 pm
by Exminiman
As apposed to the Victor Meldrew ones
……….sorry I will get my coat….
Re: At my wits end, again!
Posted: Sat Aug 03, 2024 7:15 pm
by hanlminiman
Exminiman wrote: ↑Sat Aug 03, 2024 6:28 pm
As apposed to the Victor Meldrew ones
……….sorry I will get my coat….
How dare you mention V M's coat. It's not yours they need
Re: At my wits end, again!
Posted: Sat Aug 03, 2024 8:32 pm
by InnoCooperExport
Exminiman wrote: ↑Sat Aug 03, 2024 6:28 pm
As apposed to the Victor Meldrew ones
……….sorry I will get my coat….
I can't believe it!